ExamDumpster

Free HPE6-A72 sample questions

Real questions from the Aruba Certified Switching Associate (ACSA) practice bank, with the correct answer and an explanation for each one. No junk, no filler.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 8 of 17 free sample questions.

Question 1Choose one

Core# configure terminal -Core(config)# vrf Green -Core(config-vrf)# exit -Core(config)#Core(config)# interface vlan 50 -Core(config-if-vlan)# ?Given the configuration on the CORE switch shown above, what command would follow to assign the switched virtual interface (SVI) vlan 50 to the VRF created?

Question 2Choose one

Refer to the exhibit.Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?

Question 3Choose one

What is the correct description of a Multi-Layer Switch?

Question 4Choose 2

What is true about VSX? (Choose two.)

Question 5Choose one

A network administrator is designing a high-availability solution for a campus core using Aruba CX 8325 switches. The design requires that both switches maintain independent control planes to allow for live upgrades without downtime, while presenting a unified Layer 2 interface to downstream access switches. Which technology should be deployed to meet these specific requirements?

Question 6Choose one

An administrator needs to configure a new VLAN interface on an Aruba CX 6300 switch to act as the default gateway for the 'Finance' department. The subnet is 10.20.10.0/24 and the gateway IP should be the last usable address in the subnet. Which set of commands correctly configures this interface?

Question 7Choose one

You are troubleshooting an issue where an Aruba CX switch is not receiving configuration updates from NetEdit. You suspect an issue with the REST API access or the database synchronization. In the ArubaOS-CX architecture, which specific database is responsible for holding the current operating state and configuration of the system that NetEdit interacts with?

Question 8Choose one

A technician has replaced a failed switch in a VSF stack. After the new switch boots, it does not automatically join the stack. The administrator verifies that the VSF links are connected correctly. What is the most likely cause of this issue?

9 more free samples are waiting

Create a free account to unlock the whole HPE6-A72 sample bank, or get full access to all 157 practice questions in the simulator.

Create account