ExamDumpster

Free CWAP-405 sample questions

Each free CWAP-405 sample question below comes with the answer and an explanation. Most deal with roaming problems, frame encapsulation and spectrum captures. Work through them to see how well you read Wi-Fi traffic.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 10 of 20 free sample questions.

Question 1Choose one

A network engineer is tasked with capturing traffic over a long period in a high-traffic environment to diagnose an intermittent connectivity issue. The engineer is concerned about the capture file growing too large and filling the disk. The analysis only requires examining MAC headers and the full contents of management and control frames, not the data payloads of user traffic. Which capture configuration parameter should be adjusted to achieve this?

Question 2Choose one

Station A sends an RTS frame to an AP. The Duration/ID field in the RTS is set to a value of 1500 µs. Station B is within range of Station A and hears this RTS, but it is out of range of the AP and will not hear the subsequent CTS. What action will Station B take upon receiving the RTS frame?

Question 3Choose one

You are analyzing a packet capture from an 802.11ax network. You observe a Trigger frame sent by the AP, followed by simultaneous uplink data frames from multiple clients. How does the AP communicate to each individual client which specific set of subcarriers (Resource Unit) it should use for its uplink transmission?

Question 4Choose one

While analyzing a Beacon frame from a corporate SSID, you inspect the RSN Information Element. You see one Pairwise Cipher Suite selector for CCMP and two AKM Suite selectors: one for 802.1X and one for PSK. What does this configuration imply about the BSS?

Question 5Choose one

A mobile client is performing a fast roam between two APs on the same ESS. A frame capture shows the client exchanging Authentication frames containing Mobility Domain and FT IEs directly with the target AP *before* sending a Reassociation Request. What type of FT roam is being performed, and what is a key characteristic of this method?

Question 6Choose one

A hospital's telemetry monitoring system, which uses a proprietary 2.4 GHz FHSS protocol in the 2450-2480 MHz range, is experiencing frequent data loss. The hospital's Wi-Fi network uses channels 1, 6, and 11 for patient and guest access. An analyst is brought in to investigate the RF environment. Using a spectrum analyzer in swept spectrogram view, the analyst observes the Wi-Fi signals on their respective channels. In the space between channels 6 and 11, the analyst sees very short duration, narrow-band signals that rapidly change frequency across the entire 2450-2480 MHz range. The duty cycle is low, but the amplitude of these signals is 15 dB higher than the Wi-Fi APs. Based on the spectrum analysis, what is the most likely root cause of the telemetry data loss? mindmap root((Troubleshooting)) Problem :Telemetry Data Loss Environment :Hospital (2.4 GHz) Wi-Fi (Ch 1, 6, 11) Telemetry (FHSS, 2450-2480 MHz) Spectrum Analysis Findings :Fast, narrow-band signals :Hopping between Ch 6 & 11 :High amplitude (+15 dB) :Low duty cycle

Question 7Choose 3

An analyst is troubleshooting a client connectivity issue and has a 500 MB capture file containing traffic from dozens of devices. The goal is to isolate the entire conversation for a single client, identify any retransmissions for that client, and view the timing between its frames. Which THREE protocol analyzer features would be most efficient for this task? (Select THREE)

Question 8Choose one

True or False: 802.11n (HT) was the first 802.11 amendment to introduce the use of 40 MHz channels in the 2.4 GHz band.

Question 9Choose one

In a WMM-enabled network, a video streaming client is associated with the Video Access Category (AC_VI). The AP's beacon indicates a TXOP limit of 3008 µs for AC_VI. During a video stream, the client wins contention and begins transmitting. It sends a burst of four data frames, each followed by a SIFS and an ACK from the AP. The entire exchange takes 2800 µs. The medium is now idle. What can the client do next according to WMM rules?

Question 10Choose one

A protocol analyzer is configured in monitor mode on a laptop. When observing traffic, the analyzer's statistics report a high percentage (25%) of frames with FCS errors. However, users connected to the AP are not reporting any significant performance issues. Which of the following is the most plausible explanation for this discrepancy?

10 more free samples are waiting

Create a free account to unlock the whole CWAP-405 sample bank, or get full access to all 300 practice questions in the simulator.

Create account