ExamDumpster

Free NS0-594 sample questions

Here are free NS0-594 sample questions on cluster faults, hardware and protocol problems, each with an answer and explanation. Use them to practise working from a symptom to its cause.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose one

In ONTAP's WAFL (Write Anywhere File Layout) file system architecture, what is the role of a Consistency Point (CP)?

Question 2Choose one

A storage administrator notices that after node-01 recovered from a planned reboot, a critical NAS data LIF remained hosted on node-02 instead of returning to its primary physical port on node-01. What configuration setting explains this behavior?

Question 3Choose one

A customer reports that active health alerts are present on their AFF A400 cluster. Which ONTAP command provides the specific corrective actions, probable cause, and resource identifier for active subsystem alerts?

Question 4Choose one

While investigating an ONTAP OS management hang where CLI commands through the console take over 90 seconds to respond, an engineer determines that the 'mgwd' process on node-02 has entered an unrecoverable deadlock. Which command restarts this management process without impacting client data I/O or triggering controller failover?

Question 5Choose one

Following an unexpected controller reboot on an AFF A800 node, an engineer needs to verify whether a panic event occurred and inspect the resulting core dump file. Which ONTAP CLI command displays the saved core dump status and panic string? flowchart LR Panic[Node Panic Event] --> Dump[Write Coredump to Disk] Dump --> Reboot[Controller Reboot / SFO] Reboot --> CLI[Run Diagnostic Verification Command]

Question 6Choose one

A financial enterprise operates a mission-critical 2-node AFF A900 cluster hosting ultra-low-latency SQL databases. During an unexpected power transient affecting rack A, node-01 suffers a kernel panic and halts. Node-02 immediately detects the heartbeat loss over the HA interconnect and successfully executes a Storage Failover (SFO) takeover, mounting node-01's aggregates and continuing data service. After power is restored to rack A, node-01 boots up to the 'Waiting for giveback...' prompt at the loader console. However, when the storage engineer runs 'storage failover giveback -ofnode node-01', the giveback operation is aborted with a veto message stating that uncommitted NVRAM data or pending disk sanitization / long-running operations are active on node-02. What is the correct troubleshooting sequence to safely complete the giveback without risking data corruption or an outage?

6 more free samples are waiting

Create a free account to unlock the whole NS0-594 sample bank, or get full access to all 150 practice questions in the simulator.

Create account