ExamDumpster

Free 306-300 sample questions

Each free 306-300 sample question below has the correct answer and an explanation. The set mixes Pacemaker failover, DRBD replication and Ceph storage. Read the explanations to see why each answer is right.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 10 of 20 free sample questions.

Question 1Choose one

A DRBD resource `r0` is in a split-brain state. You have determined that the data on node `srv1` is correct and the data on `srv2` should be discarded. Select the correct sequence of commands to resolve this.

Question 2Choose 2

You need to create a new LVM Thin Pool named `mythinpool` in volume group `vg0` with a size of 100G. Which TWO commands achieve this? (Select TWO)

Question 3Choose one

When configuring a bonding interface in `802.3ad` (LACP) mode, which `miimon` (MII monitoring) interval is generally recommended to ensure rapid link failure detection without causing excessive CPU overhead?

Question 4Choose one

Which of the following is the correct definition of the 'STONITH' concept in a high-availability cluster?

Question 5Choose one

You are editing the `/etc/drbd.conf` file to optimize performance over a high-latency link. Which protocol should be chosen if write performance on the Primary node is paramount and you can accept losing the most recent writes if the Primary fails and a forced failover to the Secondary occurs?

Question 6Choose one

A consultant is designing a Pacemaker cluster. They need to ensure that `ServiceB` always starts after `ServiceA`, and if `ServiceA` stops, `ServiceB` must also stop. Which single constraint type achieves both requirements?

Question 7Choose one

Which command is used to manually add a new brick to an existing distributed GlusterFS volume named `vol_data`?

Question 8Choose one

You are configuring `smartd` to monitor a SATA drive `/dev/sdb`. You want it to run a Long Self-Test every Sunday at 2 AM. Which directive in `/etc/smartd.conf` is correct?

Question 9Choose one

In a Ceph cluster, what is the primary function of the `MDS` (Metadata Server) daemon?

Question 10Choose one

A new node `node3` has been added to an existing 2-node cluster using `corosync`. After starting the service, `crm_mon` shows the node as offline. `corosync-cfgtool -s` shows the link is operational. What is the most likely cause related to the authentication key?

10 more free samples are waiting

Create a free account to unlock the whole 306-300 sample bank, or get full access to all 198 practice questions in the simulator.

Create account