ExamDumpster

Free D-NWG-FN-23 sample questions

Start with these free D-NWG-FN-23 sample questions, which come with answers and explanations. Expect questions on VLANs and LLDP, IPv4 and IPv6 addressing, and switch security. A wrong answer shows you which topic to revisit before you book.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 10 of 20 free sample questions.

Question 1Choose one

An engineer needs to identify the device name, port ID, and capabilities of a directly connected switch. Which Dell OS10 command should be used to display this information for interface `ethernet 1/1/5`?

Question 2Choose one

A new server is connected to a Dell PowerSwitch port that is part of a 4-port LACP-based LAG. The administrator connects all four network cables from the server to the switch. However, the LAG fails to become active and only one link shows as operational. Which of the following is the most likely cause for this issue?

Question 3Choose one

Which of the following IP addresses is defined by RFC 1918 for use in private networks?

Question 4Choose one

A network administrator is given the IP address 192.168.50.133 and a subnet mask of 255.255.255.224. What is the broadcast address for this subnet?

Question 5Choose one

According to IPv6 address compression rules, which is the correct way to shorten the address 2001:0db8:0000:0000:a1b2:00ff:fe34:5678?

Question 6Choose one

A Layer 3 switch has the following routes in its routing table: - 10.10.0.0/16 - 10.10.20.0/24 - 10.10.20.128/25 If the switch receives a packet destined for the IP address 10.10.20.150, which route will it use to forward the packet?

Question 7Choose one

In which scenario would a network administrator most likely choose to configure static routes instead of a dynamic routing protocol?

Question 8Choose one

A retail company has deployed Dell PowerSwitch switches in its stores. Each store has several VLANs, including one for guest Wi-Fi (VLAN 50) and one for corporate devices (VLAN 20). The company uses a centralized DHCP server located at its data center to assign IP addresses. The local switch in the store is connected to the data center via a WAN link. When a guest connects to the Wi-Fi, their device sends a DHCP Discover broadcast. This broadcast needs to reach the centralized DHCP server. The store switch is a Layer 3 capable switch with SVI's for each VLAN. What must be configured on the store switch to allow guest devices to obtain an IP address from the central DHCP server?

Question 9Choose one

A network team is investigating an issue where log messages from various network devices have inconsistent timestamps, making it difficult to correlate events during a security incident. What network service should be implemented to resolve this problem?

Question 10Choose one

A security policy requires that all traffic from the guest network (192.168.100.0/24) be prevented from accessing the internal corporate server network (10.10.0.0/16). An administrator needs to create an access control list (ACL) on the router interface connected to the guest network. Which type of ACL is most appropriate for this task?

10 more free samples are waiting

Create a free account to unlock the whole D-NWG-FN-23 sample bank, or get full access to all 240 practice questions in the simulator.

Create account