ExamDumpster

Free 300-815 sample questions

Start with these free 300-815 sample questions, each with the correct answer and an explanation. They cover SIP call flows, globalized call routing and Call Admission Control. Use them to find the call control topics you need to lab again.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 10 of 20 free sample questions.

Question 1Choose one

You are designing a globalized call routing plan for a multinational corporation. The goal is to use Tail End Hop Off (TEHO) for international calls to reduce costs. A user in the New York office (local dialing +1) dials a number in London (+44). The call should be routed over the WAN to the London gateway and then break out to the PSTN. Which configuration element is essential for this TEHO call to be routed correctly by the New York UCM?

Question 2Choose 3

Which three of the following are valid DTMF relay mechanisms that can be configured on a Cisco Unified Border Element? (Select THREE)

Question 3Choose one

A university is using Cisco UCME in a small campus building. They need to configure the system so that dialing '0' connects the caller to an external operator service at the main campus. The command to define this behavior on the UCME is `____ 0 T`.

Question 4Choose one

A company is implementing Built-in-Bridge (BiB) for call recording on their Cisco IP Phones. For compliance reasons, they must ensure that all calls made by the sales team are automatically recorded. Which configuration object in CUCM is directly associated with a directory number to invoke the BiB recording feature?

Question 5Choose one

**Case Study:** A logistics company, GlobaLink, has its headquarters in Chicago with a large UCM cluster and a primary data center. They have a branch office in Denver with 50 users. The Denver office is connected to Chicago via a 1.544 Mbps MPLS WAN link. All PSTN access is centralized through the Chicago data center via a CUBE connected to a SIP trunk provider. During a recent network event, the MPLS link to Denver became saturated with data traffic, causing severe degradation of voice quality for calls between Denver and Chicago, as well as for PSTN calls made from Denver. While the WAN link was congested but not down, users reported that calls would connect but were unusable due to choppiness and delay. GlobaLink wants to implement a solution that prevents new calls from being established over the WAN when there is insufficient bandwidth, thereby preserving the quality of active calls. **Requirements:** 1. Prevent new voice calls from being established over the WAN link from Denver to Chicago if bandwidth is not available. 2. The solution must not rely on RSVP. 3. The solution should be managed and enforced by the Chicago UCM cluster. 4. During a WAN bandwidth shortage, calls within the Denver office must still function correctly. Which solution best meets GlobaLink's requirements?

Question 6Choose one

When troubleshooting media establishment in a SIP call, an engineer notices that one-way audio is occurring. The SDP in the 200 OK message from the called party contains `c=IN IP4 192.168.10.50`. However, a packet capture shows that the calling party is sending RTP packets to a different IP address. What SIP header in the 200 OK message most likely contains the IP address where the RTP stream is actually being sent?

Question 7Choose one

A CUBE is configured with a voice translation-rule to prepend '91' to all 10-digit called numbers for international dialing. The rule is part of a translation-profile which is applied to an outbound dial-peer. The administrator notices the rule is not being applied. What is a common reason for a translation-profile to fail to apply on a dial-peer?

Question 8Choose one

True or False: The SIPREC protocol is used exclusively for forking the signaling path of a SIP call to a recording server, while the media path is forked using a separate mechanism like SPAN.

Question 9Choose one

An engineer is configuring a globalized dial plan in UCM. A transformation pattern is created to convert a 7-digit dialed number into a full E.164 number. The transformation pattern is placed in a partition called `Trans_PT` and this partition is assigned to a Calling Search Space called `Trans_CSS`. Where must this `Trans_CSS` be applied to ensure the called number is transformed before the call is routed?

Question 10Choose one

A collaboration engineer is configuring time-of-day routing for a main office number. The goal is for calls between 9 AM and 5 PM on weekdays to route to the main receptionist hunt group, and all other calls (after hours and weekends) to route to an auto-attendant. Which UCM configuration construct is used to define the '9 AM to 5 PM, Monday-Friday' schedule?

10 more free samples are waiting

Create a free account to unlock the whole 300-815 sample bank, or get full access to all 238 practice questions in the simulator.

Create account