Free 300-515 sample questions
Questions from the Implementing Cisco Service Provider VPN Services (SPVI) practice bank, with the correct answer and an explanation for each one. No junk, no filler.
Try them in the simulator Same questions, with study, timed and flashcard modes.
Showing 8 of 17 free sample questions.
During a troubleshooting session of an EVPN-VXLAN deployment, an engineer captures BGP updates to verify MAC address propagation. They observe a specific route type containing the MAC address '0050.569a.4b12' and the IP address '192.168.10.50' in the NLRI. Which EVPN Route Type is being observed?
A service provider is deploying a Carrier Supporting Carrier (CSC) architecture where the customer carrier is also running MPLS. When a packet traverses the backbone carrier's core (P routers), how many MPLS labels will be in the label stack, assuming Penultimate Hop Popping (PHP) is enabled and no Traffic Engineering is used?
An engineer is implementing Ethernet OAM on a Provider Edge router to monitor a point-to-point E-Line service. They need to configure a mechanism that continuously monitors the delay and delay variation (jitter) of the service to ensure SLA compliance. Which Y.1731 message type should be configured?
While configuring a Multicast VPN (mVPN), a network administrator wants to optimize bandwidth usage for high-volume multicast streams. They decide to implement a configuration where specific high-bandwidth groups switch from the shared P-multicast tree to a dedicated tree for that stream. Which mechanism implements this behavior?
A network consultant is designing an EVPN solution for a Data Center Interconnect (DCI). The requirement is to support multihoming where a CE device connects to two PE routers using LACP. Traffic must be load-balanced across both links (All-Active mode). Which EVPN parameter is critical for identifying this specific Ethernet segment across the PE routers?
A service provider is configuring a 6VPE (IPv6 VPN Provider Edge) service. The core network is IPv4-only and uses MPLS. Which specific BGP address family must be configured on the PE routers to exchange the customer's IPv6 prefixes with the correct VPN labels?
A network engineer is troubleshooting an issue with an E-Tree service implemented using EVPN. In this topology, traffic from 'Leaf' sites should only communicate with 'Root' sites and not with other 'Leaf' sites. Which BGP Extended Community is used in EVPN to signal the Leaf/Root role of an Ethernet Segment to enforce this split-horizon behavior?
9 more free samples are waiting
Create a free account to unlock the whole 300-515 sample bank, or get full access to all 218 practice questions in the simulator.