ExamDumpster

Free CSQP sample questions

Work through these free CSQP sample questions, each with an answer and an explanation. They cover supplier selection, performance monitoring and corrective action. Use them to check you can handle a supplier problem from first report to closure.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose one

A critical electronic component for a life-saving medical device is sourced from a single supplier. The supplier recently experienced a catastrophic failure in their cleanroom HVAC system, halting production for three weeks. To assess and prioritize the risks of similar future failures across the entire system, the quality team needs a top-down analytical tool that starts with the undesired event (production halt) and maps out all possible logical combinations of subsystem failures that could cause it. Which of the following risk analysis tools is BEST suited for this specific requirement?

Question 2Choose one

According to the Kraljic portfolio segmentation model (introduced in the 2023 CSQP BoK), a supplier that provides components with high profit impact but low supply risk should be categorized as:

Question 3Choose one

A quality engineer is analyzing a risk scenario where a product failure occurs ONLY IF both the primary sensor fails AND the backup sensor fails simultaneously. graph TD Top[Product Failure] Top --- Gate{AND Gate} Gate --- A[Primary Sensor Fails] Gate --- B[Backup Sensor Fails] If the probability of the primary sensor failing is 0.10 and the probability of the backup sensor failing is 0.05 (assuming independent events), what is the probability of the top-level product failure occurring?

Question 4Choose 2

The introduction of counterfeit parts into a supply chain can lead to catastrophic failures. Which TWO of the following are recognized prevention and avoidance strategies for mitigating counterfeit part risks? (Select TWO)

Question 5Choose one

Which of the following best describes the primary difference between a Business Continuity Plan (BCP) and a Contingency Plan in supplier risk management?

Question 6Choose one

After deploying a new inspection control plan to mitigate a recurring supplier defect, a quality professional uses the Plan-Do-Check-Act (PDCA) cycle to verify its effectiveness. During which phase of the PDCA cycle would the professional analyze the new inspection data against the expected defect reduction goals?

6 more free samples are waiting

Create a free account to unlock the whole CSQP sample bank, or get full access to all 135 practice questions in the simulator.

Create account