ExamDumpster

Free T1-T8 sample questions

Questions from the ASE Medium-Heavy Truck Certification Tests (T1-T8) practice bank, with the correct answer and an explanation for each one. No junk, no filler.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose one

A heavy-duty diesel tractor emits excessive, dense black exhaust smoke and runs roughly immediately upon cold morning startup. After 10 minutes of engine operation at highway speed, the exhaust smoke clears and idle stabilizes. What is the most likely cause?

Question 2Choose one

A Class 8 tractor powered by a 13-liter turbocharged diesel engine is dispatched to a maintenance facility due to complaints of low pulling power on grades and an audible air hissing noise from the engine compartment under load. The technician connects a diagnostic scan tool and performs a loaded chassis dynamometer test. Maximum turbocharger boost pressure achieves only 16 psi (specification is 30–32 psi). Mass airflow readings and fuel rail pressures match commanded target parameters, and no DTCs are present in ECM memory. A thorough physical inspection of the exhaust system reveals heavy black soot tracking around the exhaust manifold mounting flanges forward of the turbocharger turbine inlet. What is the root cause of the low power and reduced boost pressure?

Question 3Choose one

A Class 8 line-haul tractor equipped with a 15.5-inch two-plate pull-type clutch engages smoothly while in motion. However, with the truck stationary and the engine idling, shifting from neutral into first gear or reverse produces severe gear grinding unless the driver waits a prolonged period. Which component is the most likely cause of this gear clash?

Question 4Choose one

A heavy-duty truck equipped with an unsynchronized 10-speed manual transmission will not move in any forward gear or reverse. The clutch operates normally, the input shaft turns when the clutch is engaged in neutral, and the shift lever engages all shift rail detents cleanly. Which mechanical failure explains this total loss of drive?

Question 5Choose one

The driver of a single rear axle straight truck reports a severe howling noise emanating from the drive axle. Road testing verifies that the howling occurs exclusively when the engine is pulling under acceleration and disappears completely during deceleration coasting. What failure causes this specific noise profile?

Question 6Choose one

When reassembling a multi-piece driveshaft assembly following replacement of the center support bearing, proper driveline phasing requires that the universal joint yokes on opposite ends of each driveshaft tube segment are _____.

6 more free samples are waiting

Create a free account to unlock the whole T1-T8 sample bank, or get full access to all 151 practice questions in the simulator.

Create account