ExamDumpster

Free L3 sample questions

Questions from the Light Duty Hybrid/Electric Vehicle Specialist practice bank, with the correct answer and an explanation for each one. No junk, no filler.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose 2

A specialist is testing an isolated high-voltage orange cable harness using a megohmmeter (insulation resistance tester) after a vehicle collision. According to electrical safety standards and FMVSS 305 guidelines, which TWO statements represent correct testing procedures and evaluation criteria for loss-of-isolation testing? (Select TWO)

Question 2Choose one

A Type-1 power-split hybrid vehicle will enter the READY TO DRIVE mode, but the internal combustion engine (ICE) fails to run. During diagnostic cranking, scan tool live data indicates that engine speed reaches 950 RPM while motor-generator 1 (MG1) is spinning, yet the engine stalls immediately as soon as MG1 stops rotating. Which scan tool parameter confirmation proves that the engine is stuck in CRANK mode rather than operating under self-sustained RUN mode?

Question 3Choose one

The diagram in the figure illustrates the powertrain layout of an ASE Type-4 hybrid-drive parallel system. What is the specific mechanical function of the component labeled X?

Question 4Choose one

In hybrid vehicle powertrain control architecture, the internal combustion engine automatic stop/start strategy (Auto Stop) executes exclusively when the vehicle operational state is in the _____ mode.

Question 5Choose one

A Type-2 parallel hybrid vehicle starts normally during initial cold starts. However, after driving until warm, the internal combustion engine enters Auto Stop at a stoplight and subsequently fails to crank or restart when the driver releases the brake and presses the accelerator pedal. stateDiagram-v2 [*] --> ColdStart: Key Turn / 12V Starter ColdStart --> Driving: Engine Running Driving --> AutoStop: Vehicle Stops at Light AutoStop --> RestartFailed: MG Inactive on Restart Which component malfunction is responsible for this restart failure?

Question 6Choose one

Why is an accurate, real-time angular position feedback signal from the motor-rotor position sensor (resolver or encoder) required by the traction inverter during electrified vehicle acceleration?

6 more free samples are waiting

Create a free account to unlock the whole L3 sample bank, or get full access to all 164 practice questions in the simulator.

Create account