ExamDumpster

Free L2 sample questions

Questions from the Electronic Diesel Engine Diagnosis Specialist practice bank, with the correct answer and an explanation for each one. No junk, no filler.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose one

A technician connects a digital storage oscilloscope (DSO) and a current probe to an electronic fuel injector circuit on the Composite Vehicle Type 4, as shown in the figure. Prior to running dynamic waveform captures, the technician disconnects the injector harness to verify the internal solenoid coil integrity with a digital multimeter (DMM). What is the specified baseline resistance range for a serviceable fuel injector coil on this vehicle?

Question 2Choose 2

A diagnostic specialist is inspecting computerized engine control circuits using both a digital multimeter (DMM) and a digital storage oscilloscope (DSO). Which TWO specific diagnostic capabilities make the DSO superior to a standard DMM when troubleshooting intermittent electronic sensor and actuator faults? (Select TWO)

Question 3Choose one

The ECM on the Composite Vehicle Type 4 supplies regulated reference voltage to multiple three-wire analog engine sensors, including the Accelerator Pedal Position (APP) sensors and the Barometric Pressure (BARO) sensor. What is the regulated reference voltage value provided by the ECM?

Question 4Choose one

A technician testing the engine protection system on the Composite Vehicle Type 4 connects a digital multimeter to the engine coolant level sensor signal circuit. The multimeter reads a steady 2.5 VDC. Based on the composite vehicle engine protection and sensor voltage specifications shown in the chart, what action does the ECM initiate?

Question 5Choose one

The Water-in-Fuel (WIF) sensor on the primary fuel filter/water separator of the Composite Vehicle Type 4 is a two-wire probe circuit. What measured resistance threshold across the sensor fluid probes causes the ECM to illuminate the WIF indicator on the instrument cluster?

Question 6Choose one

A diesel engine experiences an intermittent crank-no-start condition. During cranking, the technician measures 10.6 VDC directly across the battery posts. However, back-probing between the unswitched battery power feed pin at the ECM connector and the battery positive terminal reveals a 2.3 VDC reading on the DMM. Knowing that the ECM operating voltage specification is 9.0 to 16.0 VDC, what does this measurement demonstrate?

6 more free samples are waiting

Create a free account to unlock the whole L2 sample bank, or get full access to all 158 practice questions in the simulator.

Create account