ExamDumpster

Free G1 sample questions

Questions from the ASE Auto Maintenance and Light Repair (G1) practice bank, with the correct answer and an explanation for each one. No junk, no filler.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose one

A technician checks automatic transmission fluid condition by wiping the dipstick onto a clean white shop cloth. The fluid appears dark brown to black, smells strongly burnt, and exhibits fine gritty particles suspended in the droplet. What does this fluid condition indicate?

Question 2Choose one

A technician is reassembling a two-piece driveshaft slip yoke onto its splined shaft. Why must the universal joint yokes on opposite ends of the driveshaft section be aligned in the exact same rotational plane (in phase)? flowchart LR subgraph InPhase [Proper Phasing: Yokes in Same Plane] Y1[Front U-Joint Yoke: Vertical] --- Shaft[Driveshaft Tube] --- Y2[Rear U-Joint Yoke: Vertical] end subgraph Result [Velocity Dynamics] V1[Non-uniform Speed Variation] --> Cancel[Opposing Joint Cancels Variation] --> V2[Smooth Rotational Output] end

Question 3Choose one

A technician inspects a front-wheel-drive axle assembly and notes the condition shown at label X in the figure during a multipoint inspection. What is the necessary service procedure?

Question 4Choose one

A front-wheel-drive vehicle produces a sharp, rhythmic clicking or popping noise from the right front wheel area while accelerating during sharp low-speed turns in a parking lot. Driving straight ahead under hard acceleration produces no noise. Which component is the most likely cause of this concern?

Question 5Choose one

A vehicle with an independent front suspension pulls steadily to the left on a flat, crownless highway. All four tires are inflated to placard pressure, and front caster and toe are equal side-to-side. Which front camber measurement would cause this vehicle pull?

Question 6Choose one

A technician inspects a front tire displaying the wear pattern shown in the figure. The tread along the inside shoulder at label X is worn smooth down to the wear indicators, whereas the center and outer shoulder ribs retain original tread depth. Which alignment condition is responsible for this wear pattern?

6 more free samples are waiting

Create a free account to unlock the whole G1 sample bank, or get full access to all 166 practice questions in the simulator.

Create account