ExamDumpster

Free A1-A9 sample questions

Questions from the ASE Automobile & Light Truck Certification Tests (A1-A9) practice bank, with the correct answer and an explanation for each one. No junk, no filler.

Try them in the simulator Same questions, with study, timed and flashcard modes.

Showing 6 of 12 free sample questions.

Question 1Choose one

A vehicle equipped with an electronically controlled 8-speed automatic transmission exhibits harsh garage shifts into DRIVE and REVERSE, as well as violent upshifts through all forward gears. When checking scan tool live data, the technician notes that transmission fluid temperature reads -40°C (-40°F) continuously, even after a 30-minute test drive. Which of the following explains why the transmission shifts so harshly?

Question 2Choose one

A vehicle equipped with a torque converter automatic transmission exhibits severely sluggish acceleration from a dead stop up to approximately 30 mph. However, above 35–40 mph and while cruising on the highway, engine performance and vehicle acceleration are completely normal. During a stall test, engine RPM is significantly below manufacturer specification. Referring to the internal torque converter components in the figure, which labeled component has failed?

Question 3Choose one

After installing a brand-new clutch kit (clutch disc, pressure plate, and throwout bearing) on a rear-wheel-drive vehicle, the driver complains of a severe, violent shudder and chatter when releasing the clutch pedal from a stop in 1st gear. Once fully engaged in gear, there is no slippage under full engine load. Which of the following installation errors or component defects is the most likely cause of this clutch chatter?

Question 4Choose one

In a manual transmission hydraulic clutch release system, the component mounted inside the transmission bellhousing or engine crankshaft that aligns and supports the outer tip of the transmission input shaft is the _____ bearing or bushing.

Question 5Choose one

A technician diagnoses a manual transmission vehicle where the driver complains that shifting into 1st gear and REVERSE is difficult and grinds when the vehicle is stationary with the engine running. When the technician depresses the clutch pedal to the floor with the vehicle in 1st gear and engine running, the vehicle slowly creeps forward on a level shop floor. However, with the engine off, the shifter moves effortlessly into all gear gates. What is the root cause?

Question 6Choose one

A technician is diagnosing a heavy steering complaint on a vehicle equipped with hydraulic power steering. An analyzer gauge set with a shutoff valve is connected between the high-pressure port of the power steering pump and the input of the rack-and-pinion steering gear. The diagnostic test procedure and results are summarized in the flowchart below: flowchart TD A[Start Engine & Idling] --> B[Gauge Valve Open / Wheels Centered: 110 psi] B --> C[Turn Steering Wheel to Full Lock Left or Right] C --> D[Measured Pressure at Full Lock: 520 psi - Spec: 1250-1400 psi] D --> E[Briefly Close Analyzer Shutoff Valve <= 5 seconds] E --> F[Measured Pressure with Valve Closed: 1350 psi] Based on these specific pressure test results, which component is defective?

6 more free samples are waiting

Create a free account to unlock the whole A1-A9 sample bank, or get full access to all 156 practice questions in the simulator.

Create account